Скачать с ютуб P5 Panel Build в хорошем качестве

P5 Panel Build

In this video I build a 6 foot by 3.5 foot P5 panel screen to use in my Christmas light display. I have use 1x6 boards for the box and have constructed an internal edge to mount the P4 panels to. These panels will hang from the top on my front porch under one of the eves. I plan on hoisting it into place using a pully system or small chain hoist. The following is a listing of the materials I used to build this enclosure. 1x6 boards: At total of file 8 ft boards. Four were for the outside skin and one was ripped on a table saw for the internal shelf that the P5 panels were mounted to. https://www.homedepot.com/p/1-in-x-6-... ½ inch plywood cut to approximately 6 foot 4 inches wide by 4 feet tall. 4 shelving brackets from Home Depot. https://www.homedepot.com/p/Everbilt-... Boscoyo Clear Polyocarbonate Sheet to protect the front of the panels from rain. https://boscoyostudio.com/product/cle... 42 P5 indoor panels from Wally’s Lights (buy 10% extra for future replacements). Configured for a 7 tall by 6 wide screen. https://www.wallyslights.com/collecti... Colorlight card from Wally’s Lights. https://www.wallyslights.com/collecti... Raspberry Pi 4 https://www.amazon.com/Raspberry-Mode... Three, 5 V, 300 watt Meanwell power supplies. https://www.wiredwatts.com/ps5v350wm One set of P5 and P10 Combo Side Mounting Strips from Wired Watts(7 panels tall). https://www.wiredwatts.com/pmss1 5 sets of P5 and P10 Combo Center Mounting Strip from Wired Watts (7 panels tall). https://www.wiredwatts.com/pmsc4 Two mounts for the colorlight and Raspberry Pi from Wired Watts. https://www.wiredwatts.com/pmcolorlight Three mounts for 5 volt power supplies from Wired Watts. https://www.wiredwatts.com/pmpsuback Panel Power Distribution boards from J Boards and Wired Watts (total of 6 used). https://jboards.ecwid.com/Panel-Power... https://www.wiredwatts.com/hanpaneldi...