Скачать с ютуб 3D printed J35 Saab Draken edf semi scale RC model - Available from 3DLabPrint.com в хорошем качестве

3D printed J35 Saab Draken edf semi scale RC model - Available from 3DLabPrint.com

The Saab Draken is an iconic supersonic fighter-interceptor jet which was developed and manufactured by Saab between 1955 and 1974. More than 650 Drakens were produced and it served in the Swedish Air Force and several other nations air forces including Denmark, Finland and Austria. The Draken is one of those jets that is instantly recognizable because of its double delta wing and leading edge air intakes. The semi scale model replicates these distinctive features and the elegant lines of the Saab Draken in a very precise and truthful way. No Cheater holes or non scale sized air intakes on this Saab Draken. The model will fly much like the real Draken and will even perform the famous Cobra maneuver. The model is very strong and resilient to damage, especially if printed with PolyAir 1.0 PLA by 3DLabPrint. The model requires no carbon tubes or similar for reinforcements. Just print the parts and glue them together with cyano glue. The Saab Draken model is designed to be powered by a FMS 50mm EDF and a 4S2200mAh quality battery. Only two servos are needed as the model is controlled by elevons - just like the real Draken. The model also features a large hatch for easy access to the battery and EDF. The hatch has a hidden locking mechanism that is triggered by moving the dorsal antenna forward. The model comes with a control throw gauge for easy adjusting of the correct movement of the elevons. The battery tray is spring loaded and can be positioned in three different positions making it easy to balance the model correctly at the CG point marked on the underside of the wings. A new LW-PLA version of the Saab Draken is now available for download from 3DLabPrint.com. Customers who already purchased the original PLA version can re-download the files and get the new LW-files for free. The new LW-PLA parts have been redesigned and optimized for LW-printing with minimal travel moves, which will give you strong light parts with little after print clean up. The LW-PLA Saab Draken model can be powered by a 4S 50mm FMS EDF and a 4S2200mAh battery. With this setup the Ready to Fly weight is 850g which is a weight reduction of 26% compared to the PLA version. Alternatively, the LW-PLA Saab Draken can be powered by a 3S 50mm FMS EDF and a 3S2200mAh battery. With this setup the Ready to Fly weight is 795g which is a weight reduction of 31% compared to the PLA version. The LW-PLA Saab Draken will fly both faster and slower than the PLA version and vertical performance is also improved. Hand launching of the LW-PLA Saab Draken is also easier but it is still recommended to use a catapult/bungee for safe and reliable take offs. Files for the Saab Draken can be downloaded from: https://3dlabprint.com/shop/j35_draken/ More info on my Instagram:   / hammer_design_3dprinted_planes   and RC Groups: https://www.rcgroups.com/forums/showt...