Скачать с ютуб TwinLab-F 20/40 | Application 4 | Run down & clean the extruder в хорошем качестве

TwinLab-F 20/40 | Application 4 | Run down & clean the extruder

Learn more: https://bit.ly/2rukoh3 TwinLab-F 20/40 Multi-purpose twin-screw extruder for the food and feed lab How run the extruder down and how to clean it: - Stop the cutting device - Make sure that the blade does not block the die head - Increase the feeding rate of the liquid pump in steps - Increase quantity of water - Decrease temperature, if necessary - If necessary, run the extruder with a neutral material in order to remove the old material from the barrel and the screws - Run the extruder empty - Remove cutting device - Disconnect wiring - Loosen the die insert, take it off and clean it - Disconnect the heater plug of the stock thermocouple and remove it - Disconnect the control thermocouple, heating plug and remove the round die head - Disconnect the stock thermocouple - Disconnect the pressure transducer and remove it - Disconnect the heating tape and remove it - Dismount hopper and dosing bolt - Dismount 2 side dosing plugs, 18 liner screws and ringnut adapter - Open liner - Push out the screw towards the die side - Clean the screws and the liner -- #brabtwinlabf