Скачать с ютуб How to Install FilterBalls. в хорошем качестве

How to Install FilterBalls.

Reference the "How To Guide" produced from FilterBalls. Simple, safe and easy to install. FilterBalls are easy to install. In general, follow the steps recommended by the filter housing manufacturer. Always ensure twelve inches of media above the laterals. You can mark this height on the stand pipe with a marker to ensure proper fill. If the manufacturer recommends pea gravel to support the laterals, please follow that guidance. Direction for initial start-up with System Off: 1. Remove filter sand if current vessel has sand in it 2. Clean the sand and debris that might be lodged in the lower manifold and laterals 3. Cover the stand pipe with a plastic bag and add FilterBalls to the tank. Gently press the balls down to assure proper coverage over laterals (12 inches) 4. Close the filter as according to manufacturer instructions 5. Set filter to backwash, start and run for 30sec to 1min 6. Turn off pump, set filter to rinse and run for 30sec to 1min. 7. Turn off pump, set to Filter Mode and start filter system 8. Check pressure and record, backwash when pressure increases by 5 PSI