Скачать с ютуб How to make a laser engraving machine - Part 4: Grbl 1.1 compiling, upload and configuration в хорошем качестве

How to make a laser engraving machine - Part 4: Grbl 1.1 compiling, upload and configuration

How to make 1500mW laser engraving machine Part 1: DIY control board - GRBL 1.1    • How to make a laser engraving machine...   Part 2: Build linear motion system and connect with the controller board    • How to make a laser engraving machine...   Part 3: Frame construction & connecting components    • How to make a laser engraving machine...   Part 4: Grbl 1.1 compiling, upload and configuration    • How to make a laser engraving machine...   Part 5: Test engrave some images on wood and leather    • How to make a laser engraving machine...   Safety warning: The laser used in this machine can cause permanent eyesight damage, and probably even blindness. When working with powerful lasers, always wear a pair of laser safety glasses designed to block your laser's wavelength. ------------------------------------- Watch all of my videos here:    / bakidiy   ------------------------------------- Please subscribe my channel for latest video. ------------------------------------ Grbl is a free, open source, high performance software for controlling the motion of machines that move, that make things, or that make things move, and will run on a straight Arduino. If the maker movement was an industry, Grbl would be the industry standard. Most open source 3D printers have Grbl in their hearts. It has been adapted for use in hundreds of projects including laser cutters, automatic hand writers, hole drillers, graffiti painters and oddball drawing machines. Due to its performance, simplicity and frugal hardware requirements Grbl has grown into a little open source phenomenon. Supported G-Codes in v1.1 G0, G1: Linear Motions G2, G3: Arc and Helical Motions G4: Dwell G10 L2, G10 L20: Set Work Coordinate Offsets G17, G18, G19: Plane Selection G20, G21: Units G28, G30: Go to Pre-Defined Position G28.1, G30.1: Set Pre-Defined Position G38.2: Probing G38.3, G38.4, G38.5: Probing G40: Cutter Radius Compensation Modes OFF (Only) G43.1, G49: Dynamic Tool Length Offsets G53: Move in Absolute Coordinates G54, G55, G56, G57, G58, G59: Work Coordinate Systems G61: Path Control Modes G80: Motion Mode Cancel G90, G91: Distance Modes G91.1: Arc IJK Distance Modes G92: Coordinate Offset G92.1: Clear Coordinate System Offsets G93, G94: Feedrate Modes M0, M2, M30: Program Pause and End M3, M4, M5: Spindle Control M7* , M8, M9: Coolant Control M56* : Parking Motion Override Control (*) denotes commands not enabled in config.h by default. Source: https://github.com/gnea/grbl/wiki