Скачать с ютуб 1960’S NASA ANIMATED " APOLLO LUNAR MISSION PROFILE ” OVERVIEW OF MOON MISSION EXPLAINER XD48854 в хорошем качестве

1960’S NASA ANIMATED " APOLLO LUNAR MISSION PROFILE ” OVERVIEW OF MOON MISSION EXPLAINER XD48854

Want to support this channel and help us preserve old films? Visit   / periscopefilm   Visit our website www.PeriscopeFilm.com Dating to 1965, this sophisticated animated NASA film "Apollo Lunar Mission Profile" provides an in-depth look at the manned lunar mission. The film opens with the NASA seal (:11). The Moon’s surface is riddled with craters (:23). These images had been taken from the unmanned space probe; Ranger VII, prior to the craft crashing on the moon’s surface. The mode selected to make the Apollo lunar landing possible was called a lunar rendezvous orbit (:53). A space shuttle is captured during take off utilizing rocket thrust (2:06). The captive firing of the first stage of three stages of the Apollo Saturn V space vehicle follows (2:18). Tests are conducted on the second stage’s engines (2:24). Captive firing of the third stage then takes place (2:26). A diagram is presented showing the five F1 engines (2:41), five J2 engines in the second stage (2:59) and the single J2 engine in the third stage (3:12). Tests are conducted on the launch escape system located on the top of the space craft (3:41). Portions of the Apollo space craft (3:53) are highlighted including the service module (3:57) and the lunar excursion module (4:00). The service module (4:45) and the LEM are then broken down in diagram (5:44). Ground facilities for final preparations and launching of the space vehicle are visited (5:54) in Florida and Houston, Texas. The vehicle assembly building at launch complex 39 (6:10) at the Kennedy Center is shown (6:10). The prime tool used for moving the craft is the crawler transporter (7:01). The launch pad area is zoomed in on (7:12). The launch control center is attached to the vehicle assembly building (7:29). Mission control centers are situated at the Manned Space Center (7:36) and the Space Craft Center at southeast Houston. Satellites set out in remote stations are used to provide tracking (8:03). The Boeing KC-135 Stratotanker is captured in flight (8:06). One of the remote sites used to collect information is viewed (8:14). Flight crews undergo trainings in academic class room courses (9:19). A simulator is utilized for hands on trainings (9:28). A diagram is depicted drawing attention to the three stages of the Saturn V launch vehicle (10:11). The point where the shuttle must be launched from in Florida is shown (11:25). The launch window is only about four hours (12:25). Two weeks prior to the launch, tracing ships are sent out as the remote recovery forces begin (12:55). Ground support missions are equipped and manned (13:02). The Mission Control Center at Houston and the Launch Control Center at Cape Kennedy monitor the operations (13:04). A diagram shows the pre-flight phase (13:19). A final simulated flight wraps up the testing (13:48). Once this is completed, the 24-hour count down begins (13:59). The mobile servicing structure slowly moves forward (14:13). The mission director is pointed to as to whom will receive the final reports and authorize the mission to continue (14:36). The launch director begins the automatic launch sequencer (14:41). A diagram shows how the craft first rises vertically and then begins a pitch over maneuver (14:57). The first stage burnout follows (15:39) as well as the command and service module separation (15:51). The vehicle has entered safe orbit after the second stage is jettisoned (16:27) and the boost phase is enacted (16:51). The vehicle is to make two orbits prior to heading for the moon (17:12). Landing areas are pre-determined (18:01). The second stage is re-ignited (19:27), cruising controls are set (19:27) and the transposition stage begins. After the adapter panels are opened (19:35), the module separates. A docking maneuver is depicted (19:59). The LEM is separated (22:28) after two crew members move into it. Here the crew would check for landing (23:35) and the LEM would touch down (24:20). Status reports and surveys are conducted (24:31). Selected instruments are to be left on the moon in order to conduct further studies (25:06). A rendezvous maneuver is to be conducted (27:00) to enable the lunar explorers to return to the command module (27:07). The LEM and service modules continue to orbit the Moon (27:23). As the craft moves back to the Earth, communications with ground crews begin again (24:40). The re-entry corridor is looked at showing how the module must enter (28:24). Parachutes are released including the drogue chutes (29:50), pilot chutes (29:55), and the main chutes (29:57). Actual footage from a capsule recovery in the sea follows (30:08). The film wraps up (30:51). This film is part of the Periscope Film LLC archive, one of the largest historic military, transportation, and aviation stock footage collections in the USA. Entirely film backed, this material is available for licensing in 24p HD, 2k and 4k. For more information visit http://www.PeriscopeFilm.com