Скачать с ютуб How To Wire Aeromotive's Fuel Pump Wiring Kit For Fox Body Mustangs в хорошем качестве

How To Wire Aeromotive's Fuel Pump Wiring Kit For Fox Body Mustangs

In this video, LMR covers Aeromotive's Heavy Duty Fuel Pump Wiring Kit and how to wire your Fox Body Fuel System. This explains the basic setup information so that you can get a good idea as to how this wiring kit is used in a Fox Body Mustang. Aeromotive's wiring harness consists of each wire being wrapped with mesh wire and secured with heavy duty heat shrink that ensures the mesh loom doesn't fray. Factory wiring size is not sufficient enough to handle the amp draw from aftermarket fuel pumps such Aeromotive's 340 liter per hour pump. This is why you see 10 gauge wire is used with this harness. This kit has all the needed wiring to safely run a larger fuel pump, without you having to worry about the pressure not being enough for proper combustion! ______________________________________________________ Shop SVE Fox Body Pushrod Fuel System: https://latemodelres.to/6237-P_YouTube Shop SVE Fox Body Coyote Swap Fuel System: https://latemodelres.to/6237-C_YouTube Shop Aeromotive 340 Fuel Pump & Wiring Kit: https://latemodelres.to/AMV-11540K_Yo... Shop Aeromotive Heavy Duty Fuel Pump Wiring Kit: https://latemodelres.to/AMV-16307_You... ______________________________________________________ 0:00 | Intro 0:22 | Kit Details 1:59 | Familiarize With The Harness 2:06 | Find A Suitable Place To Mount The Supplied Relay 2:39 | Install Provided Large Ring Terminal Onto The Red Power Wire 2:44 | Find A Suitable Ground For The Short Black Ground Wire 2:56 | Run The Two 18ft 10 Gauge Fuel Pump Wires To The Rear 3:16 | Once You Reach The Rear You Can Cut These Wires To Length 3:40 | Connect Red Wire Witsh Positive Stud & Black Wire With The Negative Stud 3:49 | Wire The Trigger Wire On The Aeromotive Relay Or Factory Fuel Pump Wiring As The Trigger 4:08 | Factory Fuel Pump Relay Locations 4:28 | Factory Fuel Pump Wire From Relay Under Driver's Seat Is A Pink Wire With Black Tracer 4:47 | Cut Factory Fuel Pump Wire & Splice Aeromotive Trigger Wire Into Relay Side Of Factory Wire 4:58 | Use A Heat Shrink Or Electrical Tape On Unused End Of Factory Fuel Pump Wire 5:03 | 1992-93 Models Aeromotive 12-Volt Trigger Wire Will Be Ran To The Rear 5:17 | Locate Factory Fuel Pump Wiring At Rubber Grommet On Passenger Side Of Spare Tire Well 5:23 | Cut Pink Wire With Black Tracer & Connect Aeromotive 12-Volt Trigger Wire 5:38 | For Coyote Setups Not Utilizing The Factory Wiring 6:00 | Once Wiring Is Complete Ensure Harness Is Secured & Test ForFuel Pump Operation 6:07 | Final Thoughts ______________________________________________________ YouTube: https://latemodelres.to/youtube-subsc... Facebook:   / latemodelresto   Instagram:   / latemodelresto   TikTok:   / latemodelresto   #LMR #foxbody #fuelsystem ______________________________________________________ Use of this video is subject to the terms as set forth in our LMR Install Video Disclaimer | https://lmr.com/page/lmr-install-vide...