Скачать с ютуб Super Easy Alien Coil Wire build tutorial в хорошем качестве

Super Easy Alien Coil Wire build tutorial

Hello Guy and Gals, Heres a trick to Alien coils / Alien Wire ( A KEY RING ) I know right! it keeps that core super flat, this can also be used for doing those pesky 3 core fused and Above. I recently Tried it with 5 x 30g kanthal and 1 x 40g N80 wrap. crazy easy!!! What your gonna need!!!!! Snips, Pliers, Drill, Vice, wood for vice with swivles attached to it (I just put a screw through the swivel hole and screwed it to the wood) Wire 26G and 33G wire or above possibly ceramic tweezers (Optional) Step 1: Snip 3 lengths of 26G wire approx 12 inches or so Step 2: Straighten the wire using your drill and pliers Step 3: use your 32G wire or higher, (32 is easier for begginers) and clapton one of your cores performing the clapton with a rotation on the drill where the wire will be sucked UNDERNEATH AND away youll see what i mean in the vid Step 4: Snip the core at the end of your swivel MAKE SURE to apply small amounts of pressure with your snips repeatedly and rotate your drill to slice the wire and leave no jagged edges making it easy to decore your clapton. If needed before decoring hold onto the end of the clapton portion of the wire with your pliers and rotate your drill in the opposite direction. This will loosen up the clapton portion making it easy to slide off. Step 5: pinch your loose decored clapton into the chuck of your drill and secure tighly Step 6: Stretch your clapton until your wire performs a good wave motion. if you over stretch your screwed. **** IF NEEDED stretch your core just under where you think your good and try to wrap your alien and if it is to short you can always stretch out a little farther once you have started.**** Step 7: Clear off your Table and put your core in a wide zig zag motion across the table be carefull that your core dont wrap up on itself Step 8: secure your 3 cores into the chuch making sure they are even and will rotate without to much wobble. Step 9: USING the OPPOSITE rotation that you performed your clapton secure your decored and stretched wire into the chuck of your drill and slowly start wrapping untll enough base has been layed to pinch with either pliers or your ceramic tweezers. ***YOU will see the 3 cores flatten out close together like you want them to be *** Step 10: Secure your 3 cores into your swivels Step 11: Attach your KEY RING to your 3 cores about an inch from your chuck keeping your wires flat, this attaching point is important the key ring need to be even on both sides of the wire so it does become unbalanced when the drill rotates it Step 12: Keeping your hand approx 6 inches from your wire simple lightly grasp your decored clapton and start rotating it onto your cores until you find your groove. try to stay at a 90 degree angle to your cores. if you go to far ahead your wire wont line up in the pattern and will mess up. if you go to far back it folds back on itself. Step 13: once youve reached your key ring simply stop your drill and move the key ring another bit. **** if you move your key ring to far then it does secure those cores and tightly as you want and they can fold over on themselves when applying the decored clapton. JUST Continue to apply this method untill the entire alien is completed.!!!!!! Happy Building!!!