Скачать с ютуб Wheel Stand & HOTAS Stand SIMULTANEOUSLY by using Wheel Stand Pro Deluxe V2, It's Good or Not? в хорошем качестве

Wheel Stand & HOTAS Stand SIMULTANEOUSLY by using Wheel Stand Pro Deluxe V2, It's Good or Not?

Remember: If the height of the desktop from the ground is greater than 75cm, this program cannot be used! Quickly switch between HOTAS stand and steering wheel stand without standing up from chair. Hello everyone, now I will show you how to quickly switch between flight simulation and driving simulation without even standing up from the chair. First, I will show you the overall look of the solution. Here it is, this is my Steering Wheel Stand Pro system. It cost me US$339 and also paid nearly 500 Chinese yuan in tariffs. It was very very very expensive for me, but after careful research, I finally bought it in August 2020. After several months of use, I found that my decision was correct. It saves me a lot of time and improves efficiency, which is very worthwhile. Ok, Lets make long story short. Now let me show how to quickly switch between two different situations with different game hardware: Steering Wheel and HOTAS(hands on throttle-and-stick). Now I am playing the flight simulation game X-plane 11. My desktop is not deep enough，So I do not have enough space to put paper on it after I put the keyborad and mouse at here. Now I can put paper here and use pen with it very conveniently after I move the keyborad and mouse to the stand. This is really important that you need to write some information that given by Air traffic Contorler on paper when you play flight simulation game on network, For example, on VATSIM. Now I am flying over Singapore, using the joystick and throttle, and you can use the foot rudder at the same time if you want. Ok, Next let me show you how to change to Microsoft forza Horizon 4 from X-plane 11. The first step is to loosen and release the C Clamp and pullout the screw. Then put this metal plate aside. The second step is to pull up the steering wheel and lock the two quick release pins Okay, that's all, we have completed the conversion. Finally, let me talk about the key points and shortcomings. Frist one is that I only use one screw connect these 2 parts, and also only one screw between the throttle and the little metal plate under it. They are steady enough for me, but if you can DIY, it would be better to add a screw. The second problem is that Wheel Stand Pro does support Logitech's foot rudder, but does not support the expansion board on the foot rudder. The expansion board is used to put the feet. This caused a lack of support below. Because the rudder is plastic so if there no support below it, it's maybe a hidden danger. The third problem is that I have both Logitech racing foot pedals and Logitech flying foot rudder, but these two components cannot be quickly converted. So I set the flying foot rudder to support the racing game, so there is no need to replace it. For me, this is not a big problem, but if you cannot accept this plan, then this is a fatal flaw. The fourth point is that if you also want to buy this stand, then you must include the phrase TFRP BANDS in the order's comment section, otherwise you will not receive the metal plate that I used to put the keyboard on it that shows earlier in this video. I really want to know your thoughts and suggestions, please comment below the video. Ok, thanks for watching, Seeya!