Скачать с ютуб Building a Battery Box. Part 7 - Battery Cables and Adapter в хорошем качестве

Building a Battery Box. Part 7 - Battery Cables and Adapter

In Part 7 of my Building a Battery Box series, I build the battery cables using 2 AWG marine battery cable and SB120 Anderson Power Pole connectors. When used with cable and not soldered to a board, SB120 connectors will support 225A I think. I also build an adapter from SB120 to SB50 since some of my equipment using the smaller SB50. I installed the SB120 anticipating running larger loads like a 2000W inverter. In this episode, I discuss cable glands, cable routing to reduce strain on the cable glands, stripping large cable with a utility knife, crimping lugs with a hydraulic crimper, and adhesive-line heat shrink tubing. Yellow Weather-Resistant Case: https://www.harborfreight.com/4800-we... Power Pole SB120 Connector Kit: https://powerwerx.com/anderson-sb-con... 2 AWG Marine Battery Cable: https://gregsmarinewiresupply.com/pro... Adhesive-Lined Heat Shrink Tubing: https://www.aircraftspruce.com/catalo... TEMCo Hydraulic Crimper: https://temcoindustrial.com/th0005-v2... SELTERM Battery Lugs: https://www.amazon.com/SELTERM-Marine... Part 1 - Introduction:    • Building a Battery Box.  Part 1 - Int...   Part 2 - Heater & Diffuser Plate:    • Building a Battery Box.  Part 2 - Hea...   Part 3 - Solar Charge Controller:    • Building a Battery Box.  Part 3 - Sol...   Part 4 - PVC Passthrough:    • Building a Battery Box.  Part 4 - PVC...   Part 5 - Bus Bars:    • Видео   Part 6 - Wiring the Solar Charge Controller:    • Building a Battery Box.  Part 6 - Wir...   Part 7 - Battery Cables and Adapter:    • Building a Battery Box.  Part 7 - Bat...   Part 8 - Power Pole Block:    • Building a Battery Box.  Part 8 - Pow...   Part 9 - The Battery:    • Building a Battery Box.  Part 9 - The...   Part 10 - Ampacity:    • Building a Battery Box.  Part 10 - Am...   Part 11 - The End:    • Building a Battery Box.  Part 11 - Th...