Скачать с ютуб 1998 Toyota 4runner rear axle bearing removal and install - 3rd Gen 4Runner with abs в хорошем качестве

1998 Toyota 4runner rear axle bearing removal and install - 3rd Gen 4Runner with abs

In this video I will show you how to replace the rear axle bearing on a 1998 Toyota 4runner with abs. I use a fixture that was made out of an used axle housing from the junk yard. Using this method you can remove the axle bearing, lock rings and reluctor ring at the same time without cutting them off. If you install the parts incorrectly the axle seal will be damaged or won't seal at all. This procedure will be very similar for Toyota Pickups, Toyota Tacoma, Toyota 4Runner, Toyota Hilux Surf, Toyota T100, Toyota Hilux, Toyota Tundra and Toyota Sequoya from 1981-2008. If you do this on a early non abs vehicle then you can skip the reluctor steps and the second lockring. The pipe I use to hammer the bearing and rings back on is approximately 1.63" I.D. steel pipe. A few different pressing tools are available on amazon Axle bearing tool - https://amzn.to/2x1B6X8 otc bearing tool - https://amzn.to/2oSyeZd 20 ton Shop Press - https://amzn.to/2wYjI6G Snap Ring pliers -https://amzn.to/2Qcfmkp Always check that these parts fit your exact vehicle Tone Ring - reluctor - https://amzn.to/2C4xsQb Bearing kit for 2001 and up - https://amzn.to/2EcqjPf bearing kit for 2000 and down - https://amzn.to/2QkgSRg snapring - https://amzn.to/2wXqoB7 retainer - https://amzn.to/2QJVubr axle tube oring - https://amzn.to/2UxvWgJ The above link may be affiliate links that help support this channel at no additional cost to you. Thank You If you still need to remove your axle then here is a link for that video.    • 1998 Toyota 4runner rear axle removal...   Please like and subscribe if you found the information helpful and if you have any questions put them in the comments down below.