Скачать с ютуб KBO Bike | KBO Breeze Electric Bike Unboxing and Assembly Instructions в хорошем качестве

KBO Bike | KBO Breeze Electric Bike Unboxing and Assembly Instructions

Hey, everyone! Here's KBO Bike! This is a video for KBO Breeze Unboxing & Assembly Introductions. Welcome to our official website www.kbobike.com. :) ----------------------------------------------------------------------------------------------------------------------------------------------------- 0:00 open the box 0:38 install the handlebars 1:39 install the front wheel 2:16 install fenders & the headlight 3:03 install the pedals 3:38 adjust the saddle height 3:45 check if the battery pack is locked into the frame of the KBO Breeze 4:24 press and hold "M" button for 3 seconds to power on 4:35 thumb shifter KBO Bike | KBO Breeze Electric Bike Unboxing and Assembly Instructions Open the box and it contains the owner’s manual, assembly tool, quick charger, quick release skewer, pedals, and headlight. Step 1: Install the handlebars. Remove the four screws from the stem, ensuring the linear markings on the handlebars are centered and handlebars are adjusted to the comfortable position. Finally, tighten the screws with the assembly tool. Step 2: Install the front wheel. Remove the plastic axle guards from the front wheel being sure not to touch the brake rotor set. Open the quick skewer and remove the thumb nut and cone spring. Carefully lower the fork and ensure the brake rotor goes into the caliper. Next, align the dropouts with the axle of the wheel hub to make sure the fork dropouts are fully seated on the axle. Install the quick skewer starting from the brake rotor side of the wheel and then push quick release skewer through the hub. Keep two cone springs pointed towards the wheel hub. Tighten the thumb nut until the quick release lever is held in line with the axle, and then use your palm of your hand to close the quick-release skewer. Step 3: Install fenders & the headlight. Please attach the front fender and the headlight by the screw and then connect the headlight cables according to the arrow pointing. Step 4: Install the pedals. The left and right pedals are marked on both ends. First, install the right pedal by tightening the pedal in a clockwise direction. The left pedal is tightened by turning the pedal in a counterclockwise direction. Both pedals should be tightened to 35 Newton meters by using a torque wrench. Step 5: Adjust the saddle height. loosen the seat clamp, remove the seat post and ensure the seat clamp is centered over the hole in the seat tube. Insert the seat post into the slot, adjust the saddle height to a suitable height, and tighten the adjustment nut. Step 6: Check if the battery pack is locked into the frame of the KBO Breeze. When you want to take off the battery, insert the key, and turn to release the battery pack. The battery pack can be removed and charged separately. Finally, don’t forget to connect and check the charger. Press and hold "M" button for 3 seconds to power on. The integrated brake taillight is activated when the brakes are applied. And you also can press and hold "+" for 3 seconds to open the front light and rear light. You can use the thumb shifter to change and adjust the gears. It’s worth noting that please read the owner’s manual carefully or consult a certified local bicycle service provider for assistance in addition to contacting KBO Bike for help if you have any questions.