Скачать с ютуб BGC 2.2 (2.2b2) GoPro Camera Gimbal – Software, drivers, setup and receiver connections. в хорошем качестве

BGC 2.2 (2.2b2) GoPro Camera Gimbal – Software, drivers, setup and receiver connections.

In this video I show the new gimbal (BGC 2.2 based) that I will fit to the new Hexcopter I am building for aerial photography. This particular one was bought from eBay for less than £46 and came complete with the control board and brushless motors. The very basic paper instructions that came with this gimbal can be downloaded from https://dl.dropboxusercontent.com/u/6... For a link to the drivers page visit https://www.silabs.com/products/mcu/P... For a link to the BaseCam board software visit http://www.basecamelectronics.com/dow... In this video I show the board and explain the connectors, features and software/drivers you will need to configure any setting on the 2.2b2 8 bit version of the firmware that comes on this board. One setting in particular is useful to reduce/remove the amount of buzzing or humming that you may get from the gimbal in operation. In addition I also show how to connect the gimbal to a receiver to control pitch and roll manually using a transmitter. I hope this makes it easier for those of you who are looking at this. In summary – it’s cheap and cheerful and not as powerful as some of the newer 32bit versions of the board but it does the job and is a great starter gimbal. Thanks for watching, please like and subscribe. My Helpout channel is available if you have any questions. Happy flying!