Скачать с ютуб How to Install a 2015-2017 Nissan Juke Front Bumper Cover, Part 3/3 в хорошем качестве

How to Install a 2015-2017 Nissan Juke Front Bumper Cover, Part 3/3

We'll show you how to install your Nissan Juke front bumper in an easy step-by-step fashion. Anyone can do this, so let us show you how! This is our last video on the Nissan Juke front bumper replacement. If you have not seen our other videos, I will link them below. Installing the front bumper is the same as removing it, just backward. So, if you're looking to remove your front bumper, just work your way backward in this video or click the link below. Make sure you have all your accessories back on that bumper too! Where to buy: http://bit.ly/2015JukeBumper 1)    • How to Remove a 2015-2017 Nissan Juke...   Bumper Removal 2)    • Replace Your 2015-2017 Nissan Juke Bu...   Bumper Accessories Install 00:00 Start TOOLS NEEDED: Socket wrench with 10mm socket, drill with a drill bit, Philips screwdriver INSTALL: First things first, be sure to plug the fog lights back in before mounting the bumper (1:05). We get it wrong, so you can get it right. When placing the bumper back on the vehicle, be sure to go over the rebar or steel bumper (:25). You can use the fog lights (:41) at guide points when putting the bumper on. The bumper or any and all front bumpers will clip on underneath the headlight and at the fenders. If you are mounting the bumper solo, be sure that the fender flares are not in the way (2:18). Be sure that the bottom of the bumper is over the metal frame underneath the car (2:39). Once the bumper is clipped onto the fender/bumper bracket, secure it with the 10mm bolt (3:53). Pop that fender flare back in once the fender bolt is secured (4:45). When clipping the fender flare in, there is a notch on the bumper that is used as a guide point for the fender flare (5:57). Secure the top of the bumper with the plastic push pins (7:06). There are small steel brackets that attach to the bottom corner of the bumper on each end (7:31). Lastly, don't forget to put your license plate back on. Most bumpers, whether it is aftermarket or OEM, will not have holes. Line up the license bracket and mark your holes with a pencil or marker (9:05). Use a drill bit to make the wholes but use a Philips screwdriver to secure the license plate. The drill is too powerful to use on plastic and will just make the hole bigger. That is it, you're all done. Source: https://www.revemoto.com Follow Us on FB:   / revemoto   IG:   / revemoto   Twitter: https://twitter.com/revemoto?lang=en ________________________________________________________ #NissanJuke #revemoto #paintedautoparts #Juke #DIYautorepair #BumperReplacement #nissanlove DISCLAIMER: While ReveMoto tries to make the information in this video as accurate as possible, we make no claims, promises, or guarantees about the accuracy, completeness, or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself (DIY) projects entail some risk. It is the sole responsibility of the viewer to assume this risk. ReveMoto is not responsible or liable for any loss, damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.