Скачать с ютуб How to Communicate DELTA PLC with PC в хорошем качестве

How to Communicate DELTA PLC with PC

Communicating with a DELTA PLC (Programmable Logic Controller) from a PC typically involves using communication protocols supported by both the PLC and the PC. Here's a general guide on how to communicate with a DELTA PLC from a PC: Select Communication Interface: DELTA PLCs support various communication interfaces such as RS-232, RS-485, Ethernet, USB, etc. Choose the interface that suits your setup and requirements. Install Required Software: You'll need software to establish communication between the PC and the DELTA PLC. DELTA offers programming software like "WPLSoft" or "ISPSoft" that allows you to program the PLC and establish communication. Connect Hardware: Depending on the interface chosen, make sure you have the necessary cables and connectors. For RS-232 or USB, you'll typically need a serial or USB cable. For Ethernet, connect the PLC to the local network. Configure PLC Settings: Access the DELTA PLC's settings through its programming software. Set the communication parameters such as baud rate, parity, data bits, stop bits, IP address (if using Ethernet), etc. These settings should match the settings configured on the PC. Configure PC Settings: If you're using a serial connection (RS-232 or RS-485), ensure that the PC's serial port settings match those of the PLC. If using Ethernet, ensure the PC is on the same network as the PLC and configure the IP address settings accordingly. Establish Communication: Open the programming software on your PC and establish communication with the DELTA PLC. This usually involves selecting the appropriate communication port/interface and initiating the connection. If everything is configured correctly, the software should be able to communicate with the PLC.