Скачать с ютуб Rubber Roof Install - Peel and Stick Only 2 people needed DIY, Cheap, Carport, Garage, Porch, Shed, в хорошем качестве

Rubber Roof Install - Peel and Stick Only 2 people needed DIY, Cheap, Carport, Garage, Porch, Shed,

Rubber Roof Installation DIY on a Garage, Shed, or Commercial Roof. This can be installed by two people with very few tools. We demonstrate how to install a Peel-And-Stick rubber roof with many tips and tricks to avoid leaks later on. This method is for anyone with a slightly slanted flat roof who needs to replace it. If installed correctly, this rubber roof will last 20 -30 years. #flatroofrepairs #roofrepair #chimneyrepair Shopping list for Flat Roof Installation DIY, Garage, Shed - Peel and Stick Rubber membrane Cap Sheep (any brand) - Peel and Stick Base Sheet - Karnak 81 or 66 Adhesive Trowel Grade - 1 gal of Turbo Poly Seal by Bergstromm.com - 1 Roll of Polyester fabric - Lacquer Thinners where necessary Tools Required for Flat Roof Installation DIY, Garage, Shed - Disposable brush Utility knife with straight and hook blades - Small Propane Torch - Bullnose Towel - Scissors - Stirring stick - Garbage bag - Dolly - Rags for cleaning Watch this video On how to Repair leaks on an EPDM Rubber Roof -    • Why EPDM Rubber Roofs Leak and How to...   Turbo Poly Seal at https://bergstromm.com/ Applications where Super Silicone Seal is used:    • Use this Flat Roof Coating to Repair/...   Application where Turbo Poly Seal is used:    • Anyone can Repair a Metal Roof Seam l...   Videos on Repairing Metal Roof leaks:    • Metal Roof Coating gone bad. Do not g...   Repairing Chimney leaks:    • Travelled from Pennsylvania to Skagwa...   Skylight Leak Repairs:    • Skylight leaking due to lack of curb ...   Channel: https://www.youtube.com/ @FlatRoofDoctor 1. Materials: Any roof brand peel-and-stick cap sheet and peel-and-stick base, roofing nails, and Karnak 81 or 66 trowel-grade adhesive. 2. Preparation: Sweep or blow the surface clean of dust and debris. Make sure it is dry. 3. Installation: Install over any surface. Starting from the bottom, install new metal edging, install the base over the entire surface, and then install the cap sheet starting from the bottom. Use Karnak to seal edges and end laps if the roof pitch is too low. 4. Tools: Utility knife with regular blade and hook blade, Hammer, Optional - small propane torch Turbo Poly Seal - https://bergstromm.com/ FTC Affiliate Disclaimer - I get commissions for purchases made through links in this post. Chapters: 0:00 Quick, Cheap, Easy Roof 0:25 Roof Requirements 2:38 Installing the base 5:59 Installing the Cap Sheet 8:32 Welding membrane to the wall 10:59 Installing membrane around vents 17:00 Securing roof for the night 22:33 Flashing in vents and vent pipes ‪@FlatRoofDoctor‬ ‪@AllRoof.‬