Скачать с ютуб NEW TOOL! The "Re-REEDer" Stamping Die to apply DOUBLE-SIDED Reeded Edges on Coin Rings! в хорошем качестве

NEW TOOL! The "Re-REEDer" Stamping Die to apply DOUBLE-SIDED Reeded Edges on Coin Rings!

NEW Coin Ring Finishing Tool... the "Re-REEDer! They can be found at my Shop page at: CoinRingUSA.com or by the direct link below: https://www.etsy.com/listing/51236709... =========================================== With this newest tool that I developed, you can now make your finished coin rings stand out by having reeded edges on BOTH sides instead of just one; a look hardly seen on any coin rings, until now! ;-) HOW TO APPLY THE NEW REEDS ONTO YOUR COIN RING: 1. Place your coin rings’ un-reeded (punched) edge onto the “Re-REEDER” die after annealing (and quenching) the coin's edge. 2. Using the hole in the middle of the “Re-REEDer” die as a point of reference, center your coin ring onto the grooves. 3. Next, place the piece of high-impact urethane pad (provided with this tool) over the Mint-reeded side and then put a compression press plate or coin ring Repair Die on top of the urethane pad. This will serve to protect the existing reeds from damage. 4. Line everything up under your hydraulic presses' ram head, and bring the press ram head down onto the top of the press plate/Repair Die until you begin to feel some resistance. Finally, complete 1-2 full downward strokes with your hydraulic press to imprint the reeded pattern onto the coin ring’s edge. The result will be a completely uniform pressed-on set of reeds. This tool that I developed is the best and most efficient way of accomplishing this task in the shortest amount of time with the greatest amount of consistency. Each “Re-REEDer” die is made from a solid piece of the highest quality tool steel that’s been meticulously machined and then carefully hardened for maximum efficiency. The “Re-REEDer” can also be used to re-apply reeds to any coin that have been damaged. Simply file or sand the old reeds off and re-apply using the same techniques as mentioned above. (Removing the old reeds is best accomplished using a set of Rounding, Finishing and Polishing mandrels). * My Shop page can be found at: CoinRingUSA.com Description: "NEW TOOL! The "Re-REEDer" Stamping Die to apply DOUBLE-SIDED Reeded Edges on Coin Rings!"