Скачать с ютуб How is the silver pot made? в хорошем качестве

How is the silver pot made?

When the boss wasn't paying attention, the workers scooped up the silver rice in the barrel one by one, secretly put it into a dry pot, heated it at a high temperature of thousands of degrees, melted it into a bowl of silver water, and made a handmade silver pot worth tens of thousands. The melting process of silver rice is very fast and it turns into liquid in just a few minutes. The higher the temperature, the more fluid it will be. Carefully pour it into the mold. This is not the shape of the finished product. Instead, it is first cooled to form a piece of silver. It is quickly cooled into cold water. Then it is put into the extruder and repeatedly squeezed into a thin piece. , use a spiral micrometer to measure the thickness, and only after reaching the standard can the next step of processing be carried out. In order to facilitate cutting, first heat the silver sheet to soften the steel slightly, then take out a large compass and cut it into a circle according to the marked line. It can be used directly as a pizza pan, but the master has to hammer it manually to deform it until it is It changes from a flat silver piece to a shape with a concave center and convex ends. The process requires heating. I have to say that this step looks somewhat similar to the production process of our Zhangqiu iron pot. Use a wooden stick to flatten the iron wall around it, cut off the excess part above according to the marked line, heat it again, and simply The brittleness increases its strength so that it can be stuck on a mold, directly hammer it into the shape, and make small holes densely connected one after another on it. After simple adjustment, it is already in the shape of a large bowl. , pour half a pot of water into it to absorb the heat of the lower part and prevent deformation. Only the upper part still has the curved spout to be processed. After hammering the half of the pot body into a regular shape, a small hole is made at the spout. The position of the iron rod is constantly adjusted to extend the shape of the curved spout. After that, there is a long process of trimming. process. The mouth of the pot is polished, as well as the spout, and then the manicurist's polishing machine is used to process the details, and finally a mark is made on the bottom of the pot. Do you think it's done? There are still important steps that have not been done, which are boiling hot silver water, pouring it into the mold, and making a beautiful silver dragon hand. After the master patiently adjusted it, this silver dragon hand became very delicate. It is installed on the lid. Determine the position. Heat a small silver nail at the bottom. Apply silver water on the inside. Throw it into a small pot aside and cook for a few minutes. The two will be installed together. It looks quite impressive. . Then, the master welded the small silver pillars on both sides of the tiger's mouth to catch the handle. The rest of the work was centered around the handle. He flattened a piece of silver and rolled it into a cylindrical shape. He continued to adjust its shape until the gap was completely closed. . Put it in the pot and cook for some time. Is it to prevent the silver from oxidizing? The master didn't say this, so we have no way of knowing. He simply burned off the liquid on it and welded the seams in place. Then flatten both ends of it, making sure it is stuck in the mold to prevent excessive deformation, and then the slender tail end is welded to it. In the process, the silver bars are continuously consumed, which are the ones the master cut off before. Then it was polished, the welding marks were cut out, and the piece was continuously struck with a small hammer to create a pattern like fish scales. The master took a deep breath and bent it with his bare hands.