Скачать с ютуб etrailer | Rackem Lawn Mower Grass Catcher Review and Installation в хорошем качестве

etrailer | Rackem Lawn Mower Grass Catcher Review and Installation

Click for more info and reviews of this RackEm Grass Catcher: https://www.etrailer.com/Accessories-... Check out some similar Grass Catcher options: https://www.etrailer.com/dept-pg-Acce... Click for more info and reviews of this RackEm Grass Catcher: https://www.etrailer.com/Accessories-... Check out some similar Grass Catcher options: https://www.etrailer.com/dept-pg-Acce... Click for more info and reviews of this RackEm Grass Catcher: https://www.etrailer.com/Grass-Catche... Check out some similar Grass Catcher options: https://www.etrailer.com/dept-pg-Gras... Click for more info and reviews of this RackEm Grass Catcher: https://www.etrailer.com/Grass-Catche... Check out some similar Grass Catcher options: https://www.etrailer.com/dept-pg-Gras... Click for more info and reviews of this RackEm Grass Catcher: https://www.etrailer.com/Grass-Catche... Check out some similar Grass Catcher options: https://www.etrailer.com/dept-pg-Gras... https://www.etrailer.com Don’t forget to subscribe!    / etrailertv   Full transcript: https://www.etrailer.com/tv-review-ra... Adam: Hi everyone, Adam with etrailer.com. Today, we're going to be taking a look at the Rack'em Grass Catcher. Today we have the normal grass catcher and our extension here. So we're going to go ahead and mow some grass and catch some grass.So I just went ahead and trimmed the outside of this little field here, and I noticed a little bit of grass flying up, look down, and we do have a full carrier. So I'm going to go ahead and remove this, dump it and get back to work. I'm just going to grab my handle here, rotate it up and then pull it out.All right, so I just got done mowing this backfield and to be honest, I had to unload this a lot more often than I thought. This is going to be the fifth dump. One thing I did notice is whenever it starts spewing out some of that grass, that's usually when it's full. As you can see here, I do have a lot of grass piled up. But just to show you guys, it's really easy to dump it, tilt it like this. And I have found it easier to actually take this door off. So when our catcher has room to put all this dead grass, this is going to be our desired result. As you can tell, it's very clean looking and you're not going to spend a lot of time raking up all that dead grass, which is going to give you more time to enjoy your yard with friends and family.So with this attachment, obviously we are going to add a little bit of width to our mower. And at this widest part here, it is going to be about 20 and a half inches. We aren't going to really take away any of our ground clearance because the bottom of this will be even with the bottom of our deck. One thing to note, if you are on an incline and tilted right, we might have a little bit of contact with the ground here. So just be mindful of that. And these measurements are going to be the same with all the types of grass catchers. The only thing different is we are going to have a different face plate, which is going to mount to your specific mower.So as you can see here, the face plate that we picked out for our Exmark, it definitely has a wide enough opening to where all that grass can flow in to this carrier. So our empty grass carrier here is going to be about 23 pounds. But when you buy the extension, this is going to be about 11 pounds. Or if you buy the leaf catcher, this is going to be about nine pounds. So these accessories are going to come with all the bracketry needed. This one in particular did come with this clamp here to get that fastened down and it will utilize the original door. So you don't have to worry about finding a place to store your door, it will use the same exact hardware.And the leaf catcher is going to install the same way and will come with another bracket. But I am just going to use the one on our metal extension. So this grass catcher is going to allow you to gather all that grass clipping while you're mowing. So you're not going to be spending a lot of time picking up all that dead grass. So you have a lot more time to do other things around the house. Custom face plate will be able to fit any type of mower that you do have. In this case, I have an Exmark and we picked the right face plate and it bolts it up pretty easily. It is relatively lightweight, which makes it easy to unload it when it's full of that moist grass. It is made of stainless steel and aluminum, so it's going to last you a very long time.And to be honest, I really didn't see a difference in how this mower reacted when I'm driving it. I didn't really tell that I have more