Скачать с ютуб Installing Stair Stringers with Simpson Connectors в хорошем качестве

Installing Stair Stringers with Simpson Connectors

I’m going to use these Simpson stringer connectors for the stairs in this warehouse. First, I measure down and mark the height of where I want the stringers to land. Then I mark off their spacing from left to right. Next, I install the connectors using joist hanger nails. I screw a pressure treated 2x4 to the concrete at the bottom of the stringers- this helps to hold them in place and makes the install easier. I staple sill seal to the bottom of the stringer where it contacts the concrete. Once the stringers in place at the bottom, I fasten it to the connector at the top. The connectors are adjustable- you just bend up the bottom and add one fastener. I like using these connector screws for a job like this- it goes so much faster. The bottom is secured with deck screws. I repeat the same process for the next three stringers. They ended up being about 13” on center- which will be super strong. Finally, I cut some braces the same width as the stairs- 42” wide. These temporary braces help to get all the bows out of the stringers and hold everything in place until I get the risers and treads go on. Everything turned out straight and level and all lines up. Be sure to like and subscribe to see us build the rest of these stairs. ‪@hausplans‬ #build #howto #stairs #stringers #simpsonconnectors #construction #diy #contractor #framing #carpentry #tools