Скачать с ютуб Невероятный процесс: Искусство реставрации ножей: Наследие 101 лет в хорошем качестве

Невероятный процесс: Искусство реставрации ножей: Наследие 101 лет

Restoration and restore of a 100 year old rusty cleaver knifer. The knife was very badly rusted. It had many dents and scratches. My goal with this restoration project was not to overwork the surface of the knife. It was not an easy restoration project. ============================= Social Media: My Instagram:   / mw_restoration   My Facebook:   / mwresto   ============================= First thing I did was remove the old handle. Since the cleaver was very badly rusted, it was completely sandblasted. There was still rust in the pores of the surface that could not be removed with sandblasting. That's why I treated the cleaver with electrolysis. The scabbard had a lot of dents and quirks. That's why I sanded the entire sheath. The surface was finished with a steel brush. This made the surface shiny again. All edges of the knife were ground with an arrow and sandpaper. All surfaces have been polished to a high gloss. Finally, the cutting edge was ground. The first part of the project was finished. I used oak board for the wooden handle. I cut the oak board into small slices. I always put a small aluminum plate between the individual discs. It was all glued together afterwards. The knife handle was then ground and adjusted. Finally there was the wedding. The knife handle and the knife were glued together. The result is unique. The knife is very sharp. It's a lot of fun to cut with it. If you liked the video, then read a comment and like it. Amazon Links Kärcher WD5 vacuum cleaner: https://amzn.to/3Rf3ttB Sandblasting booth: https://amzn.to/3AofFSN Blasting material: https://amzn.to/3nvW3UV Laboratory power supply: https://amzn.to/3OA4FWz Wera: https://amzn.to/3AiPPiH 00:00 Cleaver Restoration/Restore 00:17 Disassemble handle 00:39 Remove rust from knives 00:53 Sandblasting 01:25 Inspect the Cleaver 01:45 Electrolysis Setup 01:56 Set up and start electrolysis 03:05 result after electrolysis 03:21 Gsaw off cleaver knife handle 03:32 Grinding a cleaver knife 04:38 Grinding cleaver knife blade 05:17 Finish the surface with a steel brush 05:43 Grind knife bevel 06:10 Cleaver polishing 06:52 Clean Cleaver 07:16 Sharpen knife edge 09:10 Create a new knife handle from oak 09:31 Cut oak board 10:05 Cutting aluminum plate 11:00 Assemble aluminum plate and oak board 11:57 Glue knife handle 13:03 Sharpen knife handle 13:45 Assemble the knife handle and knife 14:40 Show the finished knife 15:04 Test the cleaver knife, cut paper, tomatoes, cucumbers and bread 17:11 Thanks for watching and see you next time