Скачать с ютуб Stowaway Album Tutorial - Voyage Beneath the Sea - by Cal Summers в хорошем качестве

Stowaway Album Tutorial - Voyage Beneath the Sea - by Cal Summers

Stowaway Album Tutorial - Voyage Beneath the Sea - by ‪@CalSummers‬ SHOP GRAPHIC 45: https://g45papers.com/product/club-21... "I had the Voyage Beneath the Sea Deluxe Collectors Edition as part of my Club G45 Album kit I made a super-sized Accordion album and that’s what I want to show you how to do now. There’s a full class video you can follow or I have some written instructions below. However, I thoroughly recommend using these alongside Annette’s original written instructions here. The first thing I did was cut two pieces of black chipboard at 6 ½ x 12 inches. I cut out the large semi circled mermaid signature page and cut out the mermaid from the centre. I inked the edges and made sure the image fitted on one of my chipboard pieces. I then added a piece of patterned paper to the pack of the chipboard and carefully cut out the aperture on my cover. I added patterned paper to the back cover too. There is no aperture on this piece. I used the mermaid and fish image and layered up fussy cut pieces from the other two signature sheets so that I had a real 3D image to put on my front page that would peek through the aperture cover. I then cut my hinges. I chose two different sheets of the 12 x 12 and cut six pieces in total at 12 x 4 inches. You can score on the 12 inch side every 1 ½ inches and fold and burnish so you have a zig zag shaped hinge. We are making two hinges each using three of the 12 x 4 pieces. Two of these pieces should have “mountains” at the beginning at the other a “Valley”. Glue the three pieces together with the “valley” piece in the centre of the hinges to form one long piece. Then you need to glue all the ”mountain” parts of the hinge shut so you have a total of 12 hinges. The first and last will be single unglued pieces. You need to cut the first single 1 ½ inch hinge down to half an inch. Next I measured down on the front left hand side of my aperture cover 1 ½ inches from the top and 1 ½ inches from the bottom. I took my hinges and I stuck the half inch one starting at each pencil point so that the outside single hinge piece was adhered to the outside of my cover and the first double hinge to the inside. I repeated this on the back cover. You will need to cut the first double hinge inside the aperture down as it will show through the aperture. You then need to cut your pages. I cut eight at 12 x 12 and folded right down the middle of each sheet so each page would open as if in a book, i.e. the fold on the left hand side. I used a corner rounder on all my corners and then inked all the edges. Starting with what would become my back page I opened up my cover and hinges and laid down the page on the next set of hinges from the back and I marked with a pencil where the hinges would go. I then took a sharp craft knife and carefully cut along the fold the length of each hinge. I then threaded this page on to the hinge. Repeat for all eight pages. To secure the hinges I glued the back of each hinge onto the inside right hand side page of each “signature”. I then used pattered paper or cut apart images to cover these. I took my layered up mermaid image and adhered it to the front page behind the aperture cover so it was peeking through. I then used cut aparts, chipboard images and fussy cut elements to add interest to my cover and front page." ________________________ Graphic 45 Papercrafting Award-winning papercrafting company. Offering vintage inspired art & crafting products, photo albums, and embellishments. #graphic45 https://g45papers.com/