Русские видео

Сейчас в тренде

Иностранные видео


Скачать с ютуб FENIX PD25R / เล็กพุ่งชาจได้ด้วย в хорошем качестве

FENIX PD25R / เล็กพุ่งชาจได้ด้วย 2 года назад


Если кнопки скачивания не загрузились НАЖМИТЕ ЗДЕСЬ или обновите страницу
Если возникают проблемы со скачиванием, пожалуйста напишите в поддержку по адресу внизу страницы.
Спасибо за использование сервиса savevideohd.ru



FENIX PD25R / เล็กพุ่งชาจได้ด้วย

PD25R PORTABLE RECHARGEABLE FLASHLIGHT The Fenix PD25R flashlight is a portable flashlight with a hidden Type-C charging port. The PD25R blasts an amazing 800 lumens and a total distance of 250 meters. The PD25R is powered by a single 16340 rechargeable Li-ion battery (included) or can operate on a disposable CR123A Lithium battery. The boot-up battery level indicator lets you always know the battery's status. On/off and momentary-on are activated with the tactical tail switch and six lighting modes are selected with the side switch including a strobe mode. Carry the Fenix PD25R how you want - on a backpack, belt, or MOLLE system with the two-way body clip. Compact and built-tough with an IP68 dustproof and waterproof rating, this flashlight is perfect for just about any outdoor or work activity. Size 3.62'' x 0.94'' x 0.94” / 92 x 24 x 24 mm Weight 2.75 oz / 78 g (excluding battery) Battery Type Included one Fenix ARB-L16-700P rechargeable Li-ion battery Battery Replacement Unscrew the light tail and insert the battery with the anode side (+) towards the light head, then screw the light tail back on. Charging the PD25R Switch off the light and loosen the light head to reveal the USB Type-C charging port and plug the USB A socket of the charging cable into an electrical outlet, then connect the USB Type-C socket of the charging cable to the light. The indicator will display red while charging and will turn green when fully charged. Once charging is completed, be sure to tighten the light head to maintain the dustproof and waterproof ability. Note: The normal charging time of the included Fenix ARB-L16-700P is approximately 2 hours from depletion to full charging. Recharge a stored light every four months to maintain the optimum performance of the battery. The Eco output is available while charging (press and hold the functional switch for 0.5 seconds), but the charging time will be prolonged. Battery Level Indication Each time the light is turned on, the indicator will indicate the battery level and will last for 3 seconds. Green light on: saturated 100% - 85% Green light flashes: sufficient 85% - 50% Red light on: poor 50% - 25% Red light flashes: critical 25% - 1% Note: This only works with Fenix ARB-L16-700P 16340 rechargeable Li-ion battery. Intelligent Overheat Protection The light will accumulate a lot of heat when used at relatively high modes for extended periods. When the light reaches a temperature of 60°C or above, the light will automatically step down a few lumens to reduce the temperature. When the temperature drops below 60°C, it will then allow the user to reselect the modes. Low-voltage Warning When the voltage level drops below the preset level, the flashlight is programmed to downshift to a lower brightness level until Low output is reached. When this happens in Eco output mode, the battery level indicator blinks red to remind you to timely recharge or replace the battery. Note: This only works with Fenix ARB-L16-700P 16340 rechargeable Li-ion battery. Usage and Maintenance Disassembling the sealed head can cause damage to the light and will void the warranty. Fenix recommends using only a high-quality protected battery. If the light will not be used for an extended period, remove the battery for proper storage. Unscrew the tail cap or remove the battery to prevent accidental activation during storage or transportation. Long-term use can result in O-ring wear. To maintain a proper water seal, replace the ring with an approved spare. Periodic cleaning of the battery contacts improves the light's performance as dirty contacts may cause the light to flicker, shine intermittently or even fail to illuminate for the following reasons: A: Poor battery level. Solution: Recharge or replace the battery. B: The contact or contact point of the battery or flashlight is dirty. Solution: Clean the contact points with a cotton swab soaked in rubbing alcohol.

Comments